2004 Vermeer 18x22 - SKU #9100-422

<u>MUD PUMP<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /><o:p></o:p></u>

<font>- Complete service and inspection of mud pump power end (flush crankcase, & fill with fresh oil)               </font>

<font>- Complete rebuild of mud pump fluid end (replace valves, packing cups, & inspect liners) <o:p></o:p></font>

<u><font>ROTATION ASSEMBLY<o:p></o:p></font></u>

<font>- Drain and flush rotation gearbox</font>

<font>- Replace carriage shaft seals</font>

<font>- Inspect gears, bearings, & shaft</font>

<u><font>WEAR PARTS<o:p></o:p></font></u>

<font>- Replace carriage rollers </font>

<font>- Replace rod guide rollers, bushings, and bolts</font>

<font>- Replace worn wrench slides & bars</font>

<font>- Replace sub saver</font>

<font>- Replace rod loader wear pads</font>

<u><font>GENERAL INSPECTION, MAINTENANCE AND REPAIRS<o:p></o:p></font></u>

<font>- Full service on drill (fuel, oil, air & hydraulic)</font>

<font>- Replace all filters</font>

<font>- Check all gearboxes</font>

<font>- Repair wrench base</font>

<font>- Repair left stake down auger motor mount</font>

<font>- Reseal water swivel</font>

<font>- Reseal water ball valve & adjust for complete shut-off</font>

<font>- Replace voltage stake & inspect wiring</font>

<font>- Inspect tracks, rollers, bearings, wear pads, and adjust track tension</font>

<font>- Repair engine oil leak at pressure switch</font>

<font>- Drill out broken bolts & install new rod wiper holder</font>

<font>- Replace gas shock on rear engine door</font>

<font>- Repair hydraulic leak at front rod loader shuttle cylinder</font>

<font>- Replace torn boots on rotation control handle buttons</font>

<font>- Replace missing & damaged pieces in hose carrier</font>

<font>- Replace both stake down cylinder rods (pitted & rusty) and install new seals</font>

<font>- Replace hydraulic tank sight gauge</font>

<font>- Repair damaged rear stabilizer foot</font>